Sensors

... wind head sensor to be connected to in the in-board monitoring system via the mast on a sailing boat. They are available in two lengths: The A5138 simply allows a NMEA 2000 system to be extended. Suitable for wind ...

... Dissipation Constant 5mW/ °C Probe insulation: >100MOhm Peak Voltage sustain time: 2 seconds, AC1800V 1mA 2 seconds Stress sustain: 9.8N (1kgF) for 1 minute no deformation Package Included: 1 x NTC 10K 1% Temperature ...

This temperature sensor is installed between the multisource DCDC charger and your alternator. If the sensor detects an excessively high temperature, charging will be deactivated to preserve the alternator.

Power source: 4 V - 4 V
Overall length: 281 mm - 281 mm
Overall width: 380 mm - 380 mm

... network is not affected. This also makes it possible to get an overview of smaller and remote jetties. Sensors: Various sensors identify the current status of the berth and transmit the information ...

... wind vane-anemometer. This version is optimal for installations where cable routing is difficult. The CV7SF2 wireless wind sensor features a 16Hz wind measurement frequency, which enables data refresh at 1 Hz frequency. It ...

Engineered in Marine grade cast aluminium the NT990RTU is a robust stand alone rudder angle transmission unit which provides two isolated digital outputs and one non isolated analogue output for use by proprietary navigation computers ...

Coriolis mass flow sensor for combination with MFC 010 and MFC 400 signal converters Single straight tube design Connection sizes: DN10…100 / ½…4" Tube material: Titanium, stainless steel, Hastelloy® or tantalum Overview The ...

... Device is equipped with a high quality sensor that provides ±2 % RH and ±0.3 °C accuracy in most of the operating range. Operating range is 0-100 % RH and -40..120 °C ( -40..248 °F ). The Humidity Sensor ...

... no-moving-parts wind sensor with special features for use in the marine environment. The YOUNG 85106 Marine Ultrasonic Anemometer is a 2-axis, no-moving-parts wind sensor with special features for use ...

The E-Plex 318PFTG series can be used in a wide variety of applications. The same tank sender can be used for diesel fuel, fresh water, grey water, or black water tanks. The tank gauge in its standard version can measure fluid up to a ...

... ULTRASONIC anemometer. Small and robust, get instant wind speed and direction....or track it! Built with ULTRASONIC sensors, with no moving parts to make it robust and dependable, the Ultrasonic Portable is a ...

... wire lengths, AND true omnidirectional capabilities, providing sensor data when it’s needed most. THE NOTUS TRAWLMASTER PROVIDES OPTIMAL PERFORMANCE, FOR SUPERIOR RESULTS. Notus sensors boast an ...

The Headhunter SYM-Z(R,M & S) are tank fluid level sensors that measure the hydrostatic head pressure of a column of fluid in a tank vented to atmosphere and convert the pressure into an analog signal voltage output. ...

... an ocean environment. The accuracy remains unaffected by the radial orientation and angle of loading. Additionally, each sensor stores calibration values, eliminating the need for time-consuming setup or recalibration processes.

Standalone attitude measurement system based on high-quality MEMS sensors Roll and Pitch Accuracy [RMS] - < 0.25° Magnetic heading Accuracy [RMS] - < 1° after calibration Roll Range - ± 180° Pitch Range - ± 90° Resolution ...

This is an improved design and direct replacement for the now discontinued B&G part 224-00-066. It is supplied with a 5m cable and custom lengths can be provided. Fitting is a standard 1" tube clamp.

Power source: 5 V - 10 V

The pressure transmitter of type 501 with proved ceramic technology, features adjusted and amplified sensor signals which are available as standardised current outputs. Various application-specific pressure and electrical ...

... monitoring device such as the MSP700 or MSP1500 via the NMEA 2000 CAN Bus . The RAD200 is used in conjunction with a rudder angle sensor to intuitively display the real-time position of rudder angle on the Marine Smart ...

4 - 20 mA or pulse output precision stainless steel ball bearings easy replaceable nylon cup assembly wind tunnel calibration certificate available anodized aluminum casing

The CruzPro DSP (Digital Signal Processing) active transducers output NMEA 0183 serial data of depth and water temperature. Numerous models suit most applications requiring NMEA $SDDPT, $SDDBT and $SDMTW depth/temperature data. The DSP ...

The PXT-K Series pressure transmitters are state-of-the-art instruments providing 4-20 mA output. Each Piezoresistive Pressure Transmitter contains a transducer comprised of a piezoresistive silicon chip mounted on a glass-metal feedthrough ...

... Packages Interchangeable for 12 Volt and 24 Volt Systems For use with either Max Charge or ARS-5 Voltage Regulators Battery Sensor can be used with the Digital Duo Charge MC-TS-A – Alternator Cable, 54” Length MC-TS-A80 ...

... height and Independent High Alarm combined within a single deck penetration Integral temperature detector options Flexible sensor for J-Shaped Ballast tanks

VDO Style Temperature Sender SeaGauge™ Sensor Interface Units support several types of resistive temperature senders in different case styles. Senders vary resistance with changes in temperature usually with resistance ...