Epoxy adhesive FE-220T

epoxy adhesive
epoxy adhesive
Add to favorites
Compare this product


Formulated for


TDS FE-220T Fitting Epoxy is a speciallyformulated epoxy system designed for the production boat builder. It consists of high quality resins and activators to yield a flexible bonding system for teak and most common marine substrates. Unlike most epoxies, it is a true low temperature cure down to 40° F / 4,4° C! FE-220T Fitting Epoxy is highly thixotropic, allowing it to be easily mixed, and yet stay in place when applied to the substrate. Once cured, the TDS Fitting Epoxy serves as an additional corrosion barrier to the sub-surface, and specially engineered fillers give the FE220T outstanding internal strength and waterresistance. Developed to be user-friendly, the simplified 1:1 mix ratio allows a batch of any size to be easily measured and mixed. Once thoroughly mixed, the material can be spread immediately, requiring no induction time. At 77° F / 25° C, a layer of FE-220T applied with a 3/16” / 4,5mm toothed trowel will have an open time of approximately 70-80 minutes, the material will set in approximately 4-6 hours, and complete cure will be achieved in approximately 24 hours. TDS Fitting Epoxy is DOT non-corrosive so it does not require hazardous labeling for shipment. Mixing Instructions: Stir both A & B components before combining, especially if less than a full container is being used. Mix by volume: 1 part base resin with 1 part activator. Mix well, scraping the sides of the container, until you have achieved a uniform tan color with no streaks. Mixing MUST be thorough to ensure a good cure. DO NOT ADD ANY FILLERS OR REDUCER. Application is not recommended below 40° F / 4,4° C.


*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.