Boat autopilot control unit
#230100
Tecnautic
It makes use of an already installed hydraulic or mechanical Rudder Drive or any new rudder drive. Works with 12 and 24 Volt.
It connects to the CAN-Bus cable with RJ-45 connectors which can be installed with a simple crimp tool, if custom wiring is selected. Standard cables have connectors already installed.
Two Autopilot Computers can be installed to drive two steering pumps, either alternating or parallel, in an augmentation mode, where the second pump starts only when a higher rudder speed is needed.
In Docking Mode, with individually steered rudders or stern or pod drives, the Drive-Boxes will command individual steering angles and operate the thrusters, when installed
