Tilt and trim for out-board engine
HYDRAULIC TILT & TRIM Bob's Machine Shop

For outboard owners without factory tilt and trim, Bob's Machine Shop has a solution. Designed for motors up to 40 hp, BMS's new hydraulic Tilt & Trim can provide increased performance, better handling and less hassle raising and lowering the motor at the launch ramp.

The Tilt & Trim allows skippers to trim the boat for a smoother, drier ride. When fully trimmed in, it provides a negative 3-degree tuck-under angle for faster starts and quicker on-plane times. After reaching plane, the boat can be optimized for best running angle by trimming the tilt up to its maximum of 75 degrees. A 5-1/2 inch setback is standard.

The hydraulically operated Tilt & Trim weighs only 14 pounds and will accommodate clamp-on motors,not standard BIA bolt pattern style. Call for questions.

The hydraulic pump is mounted inside the boat for protection against the elements.

The Over all mounting dimensions, which are: 11.5" wide by 10" length

BMS's Tilt & Trim is easy to install. It comes with hydraulic pump, wiring harness, control switch, hoses, oil and carries a limited lifetime structural warranty. The pump comes with a 3-year warranty.