Electric sailboat jib furler
RMEJ
ARTE - BAMAR
We have four models available:RMEJ1.02, RMEJ2.02, RMEJ3.02 and RMEJ4.02. They are all made of a hardcote anodised aluminium body
with a stainless steel cover.
If you take out the locking screws, the motorization
slides on the foil and shows the turnbuckle.
MEJ RATIO MOTOR
The worm gear ensures a safe mechanical lock when
the sail is reefed. The gear is permanently lubricated,
therefore it needs little maintenance. The high
precision machining ensures quiet operation. It may
indifferently operate clockwise or anti-clockwise.
HEIGHT ADJUSTMENT
The unit is supplied with stainless steel link plates that
raise the motorization from deck.
These link plates are pre-drilled in order to facilitate
height adjustment and make the passage of the anchor
easy.
SAIL TACK HEIGHT
The link plates, that adjust the height of the RMEJ,
may be cut to measure in order modify the height
of the tack.
FAILSAFE OPERATION
In the event of a total failure of the boat’s
electrical system, the unit can be manually
operated, by inserting a standard winch handle in
the manual emergency clutch.
USE OF THE EXISTING STAY
The motorization is hollow inside, thus allowing for the use of the existing stay and the housing of a turnbuckle.
You do not need to take off the stay from the boat, as you may install the furler on armed mast, by disconnecting the stay from the chain
plate (in some cases, you will need the installation of extra accessories for the modification of the stay – please refer to the scheme below
and to page 24 for the order).
-
zoom
