|
|
|
The newest model in the Fireboy-Xintex Carbon Monoxide Detector family, the CMD-1MR-9V is a 9V battery powered carbon monoxide detector. Ideal for boats requiring additional CO alarm protection and for boats without a CO alarm. The CMD-1MR-9V uses an advanced biomimetic sensor to determine CO levels. Time Weighted Average sensor technology is used to eliminate false alarms
|
|
|
Gasoline fumes in a bilge or engine compartment, with or without a blower fan, have the potential to be a serious risk at any time. First, because fuel leaks create new fumes as rapidly as the blower clears old fumes away. With the fan off, the hazard is increased. Second, the blower fan is typically operating prior to engine start-up, thus offering no protection from the ignition of fumes be electrical short circuit, battery hydrogen explosion, smoking or their causes. Xintex® offers a full line of gasoline fume detectors and accessories to match your specific needs.
|
|
The Contour Matrix Gas Detectors are the product of continuing research and development which BEP Marine Ltd devotes to their product range. The BEP Detectors use microprocessor control to ensure correct sensor sensitivity. The Detectors have the capability to control two sensors which detect both LPG and Petrol, with visual and audible alarms. There is a test switch to check operation of sensors with indicators for fault detection.
Features:
- Operating Voltage 10 to 32 Volts DC
- Self testing capability
- Microprocessor control
- Provision for external alarm
- Automatic shut-off solenoid control with pulse and hold circuit for low power draw (600-GDL only).
- Provision for bilge blower
- Dual sensor capability
- For remote alarm operation use part no. 54-27C4
|
|
|
The FD-2 is designed for an economic in-dash installation. Features include clearly visible LED for safe and alarm mode, and audible alarm with test function. Supplied with sensor (5 metre cable) which is capable of detecting combustible gases.
|
|
Aernautical is Firecom %u2018s extinguisher system for boat .
Activation pull.
It%u2019s suitable for vessel with engine room capacities of up to 30 cubic meters.
The Aernautical do not need of pipes or nozzle.
It%u2019s not corrosive, not toxic and is totally dielectric.
Without periodical maintenance.
Aernautical consist of:
1 aerosol generator
1 bracket
1 pulling handle with the relative connection cable.
Stainless steel made.
EXTINGUISHING AGENT QUANTITY: 500gr
DIMENSIONS: mm Ø 264 h. mm. 235
WEIGHT: gr. 5.500
ACTIVATION: Manual with 7 seconds delay
optional: mt.6 connection cable with pulling handle
RINA APPROVED FPE 140405CS/002
5-years Guarantee.
|
|
Mare30 is the aerosol extinguisher system for engine room up to 30 cubic meter .
It consist of: 2 500 g Firecom Aerosol Generator, 1 control unit, 1 control panel, stainless steel connection stirrup.
The control panel is equipped with an automatic temperature detection system able to set off the pre-alarm on reaching 80° and activate extinguishing at 105°.
Among the characteristics of the Mare30 are:
-Dashboard activation panel
-Microprocessor external relay control unit with:
Ventilation closing
Fire-fighting rolling shutter closing
Fuel electrical valve closing
Thermocord entry (automatic activation)
Remote activation push-button entry
Remote alarm entry
-Pre-alarm
-Discharge underway alarm
-5 sec.delay discharge
-Security current
-Independent feed for activating discharge
-Battery pad
-Test
RINA Approved N. FPE273305CS/04
|
|
Mare 15 is the aerosol extinguisher system for engine room until 15 cubic meter.
It consist of: 1 gr550 Firecom Aerosol Generator, 1 control unit/panel (Marcantognini) and stainless steel bracket.
The control unit indicates pre-alarm signal, alarm discharge underway with 5 sec.discharge
delay.
5 years guarantee
Rina Approved: N. FPE273305CS/03
|
|
|
Fireboy® offers five (5) and eleven (11) pound portable fire extinguishers that are the first clean-agent systems in the world to receive U.S. Coast Guard approval. A unique feature of these portable fire extinguishers is super pressurization using Argon gas that enables a user to stand as far as ten feet away from a fire.
|
|
SEA-FIRE FM-200® FD Fire Suppression Systems are pre-engineered and designed to protect enclosed compartments. All FD systems operate automatically through heat activation. Discharge will occur when the sensor valve temperature rises to the system activation point as shown on the label attached to each unit. Systems with a manual ("M") designation contain a manual capability feature. This provides the boat operator with the option of pulling a discharge cable which activates the fire system. SEA-FIRE FM-200® FD extinguishing systems are designed to induce minimum atmospheric concentration of 8.7% within the protected compartment.
SEA-FIRE FD series extinguishers are equipped with a factory installed pressure switch which is intended for cylinder pressure supervision and may also be used to control other electrical functions (engine shutdown, air exchange equipment, etc.).
|
|
SEA-FIRE FM-200® FG Fire Suppression Systems are pre-engineered and designed to protect enclosed compartments. All FG systems operate automatically through heat activation. Discharge will occur when the sensor valve temperature rises to the system activation point as shown on the label attached to each unit. Systems with a manual ("M") designation contain a manual capability feature. This provides the boat operator with the option of pulling a discharge cable which activates the fire system. SEA-FIRE FM-200® FG extinguishing systems are designed to induce minimum atmospheric concentration of 8.7% within the protected compartment.
SEA-FIRE FG series extinguishers are equipped with a factory installed pressure switch which is intended for cylinder pressure supervision and may also be used to control other electrical functions (engine shutdown, air exchange equipment, etc.).
|
|
|
|
|
|
|
SEA-FIRE FM-200® Stinger FT Automatic Fire Suppression Systems are pre-engineered and designed for ease of installation in highly complex applications. The systems are self-activating, require very little maintenance and provide a cost effective solution for applications including marine, recreational vehicles, and commercial and industrial use where flammable liquids are likely the source. Stinger FT Series require no external power so they are not sensitive to power failures or shut downs. The Stinger FT Series is ideal for small volumes, 150 cu.ft (4.2 cu.m) or less.
The direct low-pressure system utilizes the tubing as both the detecting device and agent delivery system. When temperatures go beyond 175°F (79°C), the portion of the tubing nearest the hottest part of the flame will rupture forming a mini discharge nozzle. In a fire condition, the agent is released via the small nozzle and the system continues to discharge the agent until the entire contents of the cylinder is expended.
|
|
|
Gloria 1kg portable shrouded valve powder fire extinguisher, which comes complete with mounting bracket and pressure indication guage.
|
|
Manual Fire extinguisher, for fighting fire in your home and your car.
Easy to operate, light weight (250gr), non toxic, no mass, no residue, no maintenance.
|
|
Marine Fire Extinguisher. Compact Design. Easy-Test pressure check. Perfect for personal watercraft (PWC) storage containers. Effective against flammable liquid fires and "live" electrical equipment fires.
|
|
| ... products without information |
| |
|
|
Fire fighting for boat
