|
|
GOODE PowerShellTM Introduction
At GOODE, we started from the ground up to design a water ski marine boot system that increases edge power, control and comfort over rubber marine boots.
Water ski boots must perform two functions; 1.) Hold your foot to the ski and provide control and 2.) To release from your foot in a bad fall. Rubber boots do neither well. The tighter you make the rubber boots for increased control, the more they hurt and the less they come off in a fall. The looser you make a rubber boot the more comfort and safety you will have, but you will lose control and power.
The GOODE PowerShellTM System does both of these functions better. The GOODE PowerShell Boots fit comfortably on your feet and provide increased edge control and power. The InterLocTM System is mounted on a binding plate that is releasable from the ski. It's a screwless binding system. |
|
The Performance Series High Wrap is used by tournament water skiers and features thick rubber for extra lateral support to eliminate unwanted movement. The Performance Series can be custom sized using the rubber overlays.
Custom Size the Performance Bindings using the following instructions:
GET WET: Make sure the foot and the bindings are wet before attempting the following adjustments.
ADJUST BINDING WIDTH: N/A
ADJUST LATERAL SUPPORT: Remove the binding from the ski. Unscrew rear horseshoe from under the plate. Pull or loosen rubber overlay to desired size. Replace horseshoe. Screw the binding to the ski. Test adjustment while skiing. Once exact overlay placement is decided, GOODE recommends cutting off any extra rubber one inch or more beyond the edge of the plate to prevent excess rubber from dragging in the water.
|
|
| Never before has a high end binding provided ultimate lateral support with unsurpassed heel hold down while still being easy to get in and out of. We introduce the Draft with patent pending Hinge Tech. The first and only step in slalom binding on the market. Pull down the lever and simply step into the binding effortlessly. Pull the lever up and give the laces a tug. Simple as that, no strain, no stress. You now have more energy for the best slalom set of your life. High and stiff the Draft features a molded lycra lined toe rubber so you feel like you have been breaking it in for years the first time you put it on. A neoprene lined heel rubber with perfectly positioned achillies pads for boats give performance and heel hold down feeling like you have never felt. A leather wrap holds you tight to the marine ski translating into responsiveness previously only dreamed about. Comfort lead to performance. The Draft delivers both better than any other binding on the market. |
|
Fastback Marine plates
The overwhelming success of the Draft inspired us to develop the next step in Hinge Tech slalom bindings. We introduce the Fastback. Bringing the patented Hinge Tech to the masses with the first and only step in waterski binding at a value price. Pull the lever down and step in the Fastback effortlessly. Pull the lever up and feel the zero heel lift for boat as the achillies pads for boats hold your heel solidly in place. Give the laces a pull and you are in for a nice smooth ride. The Fastback also features a leather and single lace system as well as padded Gorilla Grips. A soft foot pad cradles your foot and the side-mount hardware allows for a comfortable fit. The Fastback is seriously the binding you have been waiting for. |
|
The easy entry, front lacing shock boat boot was also improved for 2007 with a floating tongue which allows easier entry for a larger range of foot sizes and shapes. Now everyone in the family can enjoy a day on the water with this one boot.
|
|
The "fan favorite" venom boat boot is updated for 2007 with a new, soft EVA tongue to give you increased performance while maintaining the comfort you have to come to love from the venom boot. The new layered overlay construction, with specifically designed articulated stretch zone and stylish leather patches, is the icing on the cake.
|
|
For 2007, the classic Animal binding is modernized with an updated, layered overlay construction comprised of a stronger TPU material and embossed synthetic leather. This provides a cutting edge look with superior performance. The newly created "stretch zones" are specifically designed to allow the boat boot to stretch in the areas you want for easier entry and less cramping, while still providing optimal support in the areas needed.
|
|
Yardarm's personal watercraft Jet Cart is designed with the boat dealer in mind
Manufactured with heavy steel construction
Painted wood bunks run the full length with carpet for hull protection
Two 12" pneumatic tires
Push-pull handle
2" coupler and tounge
600 lb. sailboat winch
Jet Cart allows one man operation for loading and launch of personal watercraft
Yardarm's Jet Cart is built to last for the service shop
|
|
Carriage of workshop aluminum for Jet with Arm & Jet with Saddle
Leger-Handy-robust AJB & AJS |
|
Carriage of setting to water Towable aluminum for Jet with Saddle
Leger-Dismountable-Adjustable-towable JET4L
carriage of setting to water JET4L
Frame Anodic Aluminum
Wheel axle stainless
7 boat shoes of yellow protection (good visibility)
2 low wheels pressure dismountable
Dismountable tiller of traction
1 head of attachment
1 marine winch with strap
Nuts and bolts stainless
Overall length: 2m75
Length of the slopes: 1m20
Total width: 1m10 Distance between centres of the slopes: 0m51
Total height: 0m49
Weight: 35kg
Payload 450kg |
|
Carriage of setting to water Towable aluminum for Jet with Arm
Leger-Dismountable-Adjustable-towable JET3L |
|
Carriage of setting to water aluminum for Jet with Arm
Leger-Dismountable-adjustable JET1 & JET1L |
|
| ... products without information |
| |
Ideal for PWCs, dinghies for boats, small jet boats and flat boats, the SunLift Mini move you quickly and smoothly. With a touch of a button from your optional key-chain remote, you’ll be on your way to summer fun in seconds. Bottom-based, there’s no dock for boats modification needed. And, the portable fiberglass powerpack can be placed on your dock or mounted to the lift for boat on a shelf.
|
|
The Up-N-Over™ is built with all stainless steel and aluminum construction and features both a custom-designed and manufactured heavy-duty mast, as well as custom made aluminum bunks. The sleek white powder coat finish adds to the appearance of your dock for boats and allows for easy cleaning. We also added refinements such as custom made end-caps for all aluminum bunks, cradle arms, and pipes.
Up-N-Over™ lifts for boats readyMost important of all, the Up-N-Over™ PWC lifts are ready to do everything you require. You can raise, lower, and rotate 180° and then lock into place for service. These lifts offer an impressive combination of performance, reliability, ease of operation and installation, and the type of refinement only found in a professionally engineered product. Boat Lift U.S.'s boat masts are completely un-submerged, keeping your lift clean and looking new as well as allowing for years of trouble free operation |
|
The Mini Mag Personal Watercraft Lift for boat was designed as a user friendly solution to storing your personal watercraft (PWC) or small boat. No lines to tie and no trailers for boats needed. The Mini Mag uses forklift-like arms to raise and lower your craft from your own pier. The low profile design makes this lift very attractive.
The Mini Mag is available in 800 lb. and 1,500 lb. weight capacities. Both models are available with either manual or electric boat winches. A boat radio remote control is available as an option with the electric model.
The Mini Mag's track is secured to a piling with the supplied galvanized mounting hardware. The carriage travels through the track on polypropylene rollers and is raised and lowered by a stainless steel cable. Carpeted runners support and protect the bottom of the watercraft. |
|
PWC and Small Boat Lifts for boats
I.M.M. boatlifts offers 1,000 lb. pwc lift, 1,500 lb., and 3,000 lb. lift which lifts 2 pwc units. The 1,000 lb. Single pwc lift mounts to one piling. This lift can swivel 210 degrees which allows the pwc to be lifted from the water and rotate over shore where it can be rested. The lift also does not have a fixed piece of structure that stays in the water. The 1,500 lb. small boatlift mounts to one piling. It comes standard with plate drive gearing, aluminum grooved cable winder, and Perma Bunks standard. The 3,000 lb. dual pwc lift mounts to two pilings. This lift holds two pwc units side by side with a walkboard mounted between the two pwc units for easy access. |
|
Get out onto the glassy water faster with AirBerth Boat Lifts for boats, Ultimate Boat Protection!
An AirBerth Boat Lift eliminates the need to marine trailer your boat and is perfect for holiday home boating. Launching in as little as 2.5 minutes, you will be enjoying the glassy conditions which only the early morning can bring, before the hordes get to the skiing spots!
Keep your hull sparkling has never been easier with AirBerth's hull rinsing system. Simply plug your hose in and the AirBerth will take care of the rest.
best of all the AirBerth is designed specifically with Shaft Drive boats in mind, making docking a pleasure not a chore!
So why keep waiting at boat ramps, invest in an AirBerth today and start getting more serious 'Air Time' with AirBerth, Ultimate Boat Protection. |
|
| ... products without information |
| |
| The WaveRider 2008 X700 GT features a 95 horsepower 2 cylinder 2 stroke engine for boat that is reliable and proven. With a top speed of about 50 miles per hour this pwc has excellent power at all speeds and with seating for up to 3 persons so you can share the fun. |
|
The GP®1300R is powered by a high-performance, fuel-injected 170 horsepower, three-cylinder, 1296cc Yamaha marine engine for boat.
Electronic Fuel Injection (EFI): Computer-controlled, electronic fuel injection system automatically adjusts fuel flow and ignition timing for quick throttle response, maximum acceleration, and improved fuel efficiency.
Yamaha Engine Management System (Y.E.M.S.): An integrated, computerized management system that controls and adjusts such functions as ignition timing, fuel injection mapping, engine diagnostics and off-throttle steering. The OTS function of YEMS activates when the operator releases the throttle lever and attempts to steer the watercraft. This assists the operator in turning while the watercraft is decelerating.
Traction Control: To manage the awesome power of the GP1300R, Y.E.M.S. utilizes a traction control feature that alters fuel/air mixtures. This system enhances acceleration by reducing prop spin and achieves top end performance by maintaining engine RPM. |
|
Fun Factory, based in Toulouse (France), is a company which conceives, makes and commercializes nautical products; created in March 2007, our company markets a new innovative product to revitalize the market of the Jet.
Being able to welcome up to 6 persons, the Wave-Boat is a hull of boat entirely realized in rotomolded three coats polyethylene, recyclable in 98 %. This material make it very resistant in shocks.
The WAVE BOAT will make your exits more family, pleasant and funnies. The hull addition will offer new sensations and possibilities to the Jet.
Conceived to be motorized by YAMAHA® Wave Runner models FX or VX , marketed from February 2008 in authorized Yamaha's dealers and available in two versions, the WAVE BOAT will be the ideal companion of your exits in Jet.
For further information, contact us: contact@fun-f.com or visit our Web site: www.fun-f.com |
|
| ... products without information |
| |
FEATURES
SIZES: 64.0", 66.0", 68.0", 70.0", 72.0", 75.0"
WIDE RAILS– Provides stability
NARROW TUNNEL– Predictable tracking
WIDE FOREBODY– Easy starts and turn initiation
45 DEGREE EDGE BEVELS– Reduces spray and reduces fatigue
DROP THOUGH MARINE FIN– No hassle fin adjustment
The #1 selling slalom ski in the world and the ski that taught the world to slalom. A wide forebody and deep tunnel make the World Team a great ski to learn and progress on. The A.R.C. adjustable fin lets you fine tune the ski to your size and style. 45 degree bevel gives great stability on edge and a dry ride. Available in six sizes, there’s one made for everyone.
FIN SET-UP: A.R.C.
BINDING SET-UP: X-9
|
|
The SIXAM SS
The new O'Brien SixAM SS is being introduced this spring as a replacement for the SixAM 1.0. The SixAM SS is the fastest ski we have ever built, yet it still carves and finishes turns very well on both your on and off side turns. You simply will not believe how early and wide you arrive at every marine buoy and how much angle you achieve coming out of the turn. With each length of ski going through an individual redesign process, each ski length will see changes on everything from transitional bevels to rocker and will have new flex patterns developed to make you ski your best. The new SixAM SS series is a quantum leap on the evolutionary scale of water skis for boats. |
|
|
|
see the results for the following category