|
|
SeeLeveL 707, multi tank monitor system for plastic tanks
This level gauge has an easy to read LED display. Display fresh, gray, or black tank levels at the press of a button. 9 segmented display gives accuracy to 1/8 (12.5%) of a tank. Orange and red indicators are used for low and empty level warnings for the fresh water tank. Orange and red indicators are used for high and full level warnings for the gray and black water tanks. 3 sender boards are included.
Art No 970206
|
|
SeeLeveL 713, multi tank monitor system
No buttons to push! The level of each tank, plus the outside temperature, is shown individually. 713 provides accurate tank level information in percentage of full. Measures tanks up to 430 mm tall with a single sender or 840 mm tall with dual senders. 3 sender boards are included.
Art No 970220
|
|
Gobius 4WF - For water- or diesel tanks in stainless steel, steel, plastic and aluminium
All Gobius products measure from the outside, avoiding the need of to take the tank apart and drill unnecessary holes.
- Very easy to use
- Traffc lights lamps show the current liquid level
- Automatically checking the level
- No extra service is needed
- Extremely low electricity consumption
30 minutes to install
On the sensors there are strips of tape that are provided to attach the sensors directly onto the surface of your tank. The panel may be placed in the pentry or at the electric control panel. All necessary cables and plugs needed to connect the sensors and panel with the control unit are included.
Very easy to calibrate
No tanks look the same. There are always differences in e.g. size, construction, thickness and age. In order to compensate for these differences you have to calibrate the tank before you start to use your Gobius. However, the calibration only takes a few seconds, all you need to do is to press a button while the tank is full.
Extremely low electricity consumption, less than 40 mA (12 volts)
Gobius is constructed to minimise electricity consumption and is extremely efficient. Gobius sends power to its sensors in impulses instead of a continuous supply, thus saving your craft’s battery.
Art No 970381 Gobius 4WF for tanks in stainless steel, steel & aluminium
Art No 970193 Gobius 4WF for tanks in plastic
|
|
SeeLeveL 709, multi tank monitor system
This system provides an outstanding balance between low cost and full features. Instead of single points that give you only a close appr. of how full your tanks are this system offers a continuous level and shows an actual number, in percent of full.
Measures tanks up to 300 mm tall with a single sender or 600 mm tall with dual senders. 3 sender boards are included.
Art No 970213
|
|
Gobius 4 for holding tanks in stainless steel, steel, plastic & aluminium
Gobius has been developed to meet the demand from those boat owners who want more information, those who not only want to know when the tank is full.
All Gobius products measure from the outside.
-Coloured lamps show the current fluid level
-You avoid the struggle with taking the tank apart
-No extra drilling of hole
-No need for extra service
-Extremely low electricity consumption, less than 40 mA
-Good for everybody: boat owners and environment
30 minutes to install
On the sensors there are strips of tape that are provided to attach the sensors directly onto the surface of your tank. The panel may be placed in the washroom. All necessary cables and plugs needed to connect the sensors and panel with the control unit are included.
Very easy to calibrate
No tanks look the same. There are always differences in e.g. size, construction, thickness and age. In order to compensate for these differences you have to calibrate the tank before you start to use your Gobius. However, the calibration only takes a few seconds, all you need to do is to press a button while the tank is empty.
Extremely low electricity consumption, less than 40 mA (12 volts)
Gobius is constructed to minimise electricity consumption and is extremely efficient. Gobius sends power to its sensors in impulses instead of a continuous supply, thus saving your craft's battery.
Art No 970091 Gobius 4RFP for tanks in stainless steel, steel & aluminium
Art No 970053 Gobius 4RFP for tanks in plastic
|
|
You want to stay in complete control of the situation and have accurate information. Guesswork is not good enough when it comes to the status of your power system.
How much longer will my service battery last? What condition is my starter battery in? How much current is being recharged? How long do I have to wait for my battery to be fully recharged? How many charge cycles has my service battery undergone… The answers to all these questions can be provided by Mastervolt’s instrumentation.
|
|
In addition to providing complete management of your vessel's fuel flow and fuel remaining, Navman's Fuel 3100 utilizes speed data from GPS or paddlewheel input to calculate real-time fuel economy data. The Fuel 3100 can be programmed to display these values in miles per gallon or litre.
This important information allows you to determine the optimum throttle and trim settings for single and twin engine boats. This will save you money on fuel and minimize long-term engine wear by running your engines at their most efficient settings.
|
|
| ... products without information |
| |
|
This 300 bar (4350 psi) pressure gauge is a small model that will not be in the way during the dive. Made of robust metal. With Poseidon’s 300 bars kevlar hose.
|
|
AP508A Miniature Pressure Gauge
Designed for divers using off-board gas cylinders this superb mini gauge eliminates the clutter of conventional hoses & gauges. The AP508A screws directly into the regulator's 1st stage HP port (7 / 16" UNF thread).
0-350 Bar markings are black against a white face for optimum clarity.
|
|
Halcyon's standard DIR Pressure Gauge is just what you would expect in a DIR SPG: low tech, reliable, and accurate. The classic heavy-duty brass housing and tempered glass lens will stand up to any environment, and the gauge face is clean and easy to read in all conditions. The weight and size of the gauge makes it best suited to serve as a primary SPG for your back gas.
|
|
Mechanism: spiral (Patented)
Module: stamped and chrome platted brass
Hose: Hi-resistant HP hose
Thread: male 7/16" female 7/16"
Hose length: 800 mm
Face: luminescent
Glass: Hi-resistant Polycarbonate
Range: BAR 0 - 400 (10 bar increment)
Certified CE EN 250
|
|
|
Precision 80 metre altitude adjustable depth gauge with maximum depth indicator. Complete with high quality rubber housing and velcro fastening wrist band.
|
|
| ... products without information |
| |
|
|
see the results for the following category
