|
|
SeeLeveL 709, multi tank monitor system
This system provides an outstanding balance between low cost and full features. Instead of single points that give you only a close appr. of how full your tanks are this system offers a continuous level and shows an actual number, in percent of full.
Measures tanks up to 300 mm tall with a single sender or 600 mm tall with dual senders. 3 sender boards are included.
Art No 970213 |
|
SeeLeveL 707, multi tank monitor system for plastic tanks
This level gauge has an easy to read LED display. Display fresh, gray, or black tank levels at the press of a button. 9 segmented display gives accuracy to 1/8 (12.5%) of a tank. Orange and red indicators are used for low and empty level warnings for the fresh water tank. Orange and red indicators are used for high and full level warnings for the gray and black water tanks. 3 sender boards are included.
Art No 970206 |
|
SeeLeveL 713, multi tank monitor system
No buttons to push! The level of each tank, plus the outside temperature, is shown individually. 713 provides accurate tank level information in percentage of full. Measures tanks up to 430 mm tall with a single sender or 840 mm tall with dual senders. 3 sender boards are included.
Art No 970220 |
|
Gobius 4WF - For water- or diesel tanks in stainless steel, steel, plastic and aluminium
All Gobius products measure from the outside, avoiding the need of to take the tank apart and drill unnecessary holes.
- Very easy to use
- Traffc lights lamps show the current liquid level
- Automatically checking the level
- No extra service is needed
- Extremely low electricity consumption
Gobius is easy to install
On the sensors there are strips of tape that are provided to attach the sensors directly onto the surface of your tank. The panel may be placed in the pentry or at the electric control panel. All necessary cables and plugs needed to connect the sensors and panel with the control unit are included.
Very easy to calibrate
No tanks look the same. There are always differences in e.g. size, construction, thickness and age. In order to compensate for these differences you have to calibrate the tank before you start to use your Gobius. However, the calibration only takes a few seconds, all you need to do is to press a button while the tank is full.
Extremely low electricity consumption, less than 40 mA (12 volts)
Gobius is constructed to minimise electricity consumption and is extremely efficient. Gobius sends power to its sensors in impulses instead of a continuous supply, thus saving your craft’s battery.
Art No 970381 Gobius 4WF for tanks in stainless steel, steel & aluminium
Art No 970193 Gobius 4WF for tanks in plastic |
|
Gobius 4 for holding tanks in stainless steel, steel, plastic & aluminium
Gobius has been developed to meet the demand from those boat owners who want more information, those who not only want to know when the tank is full.
All Gobius products measure from the outside.
-Coloured lamps show the current fluid level
-You avoid the struggle with taking the tank apart
-No extra drilling of hole
-No need for extra service
-Extremely low electricity consumption, less than 40 mA
-Good for everybody: boat owners and environment
Gobius is easy to install
On the sensors there are strips of tape that are provided to attach the sensors directly onto the surface of your tank. The panel may be placed in the washroom. All necessary cables and plugs needed to connect the sensors and panel with the control unit are included.
Very easy to calibrate
No tanks look the same. There are always differences in e.g. size, construction, thickness and age. In order to compensate for these differences you have to calibrate the tank before you start to use your Gobius. However, the calibration only takes a few seconds, all you need to do is to press a button while the tank is empty.
Extremely low electricity consumption, less than 40 mA (12 volts)
Gobius is constructed to minimise electricity consumption and is extremely efficient. Gobius sends power to its sensors in impulses instead of a continuous supply, thus saving your craft's battery.
Art No 970091 Gobius 4RFP for tanks in stainless steel, steel & aluminium
Art No 970053 Gobius 4RFP for tanks in plastic |
|
You want to stay in complete control of the situation and have accurate information. Guesswork is not good enough when it comes to the status of your power system.
How much longer will my service battery last? What condition is my starter battery in? How much current is being recharged? How long do I have to wait for my battery to be fully recharged? How many charge cycles has my service battery undergone… The answers to all these questions can be provided by Mastervolt’s instrumentation. |
|
In addition to providing complete management of your vessel's fuel flow and fuel remaining, Navman's Fuel 3100 utilizes speed data from GPS or paddlewheel input to calculate real-time fuel economy data. The Fuel 3100 can be programmed to display these values in miles per gallon or litre.
This important information allows you to determine the optimum throttle and trim settings for single and twin engine boats. This will save you money on fuel and minimize long-term engine wear by running your engines at their most efficient settings. |
|
| ... products without information |
| |
You want to stay in complete control of the situation and have accurate information. Guesswork is not good enough when it comes to the status of your power system.
How much longer will my service battery last? What condition is my starter battery in? How much current is being recharged? How long do I have to wait for my battery to be fully recharged? How many charge cycles has my service battery undergone… The answers to all these questions can be provided by Mastervolt’s instrumentation. |
|
The amps measure with a shunt in a positive circuit by a digital instrument is very rare and is non-existent in marine or only by parades which consist to make a negative "return" by the shunt wiring. It is due to the technical difficulty to use a +12V (or +24V) in reference to place of the zero/mass of the battery negative.
Measure on the Positive by shunt
Selection of shunts from 10 to 1000A
Very hight accuracy
Immediate permanent display
Flow current indication by green / red LED
Display resolution from 10mA
Compact LCD Ammeter 80x80mm
Very low powerconsumption 15mA@12V / 7,5mA@24V
The universal ammeter NL227-001 allows an immediate reading of a direct current in Amperes, which results from sources of charge (alternator, battery charger, solar panels, etc.) and consumers in service who discharges the battery. It is the only device which can give an exact measure of an electric DC current.
Using a shunt allowing a hight accuracy for practise this measure. The shunt takes place in the positive circuit to be monitored. |
|
| ... products without information |
| |
|
|
see the results for the following category
