|
|
|
|
|
|
|
A clima inverter chiller is a system which can be installed in the engine compartment. This chiller unit will control its capacity according to what is being demand in its surroundings due to the applied inverter compressor technology. There is no current peak when switching on the compressor! The chiller unit supplies cold/hot water (glycol) which flows through a tubing circuit and fan coil units, (through which air is pulled at the same time) and as a result it cools/heats the surrounding areas. This system can cool any given area/cabin, and the temperature and airflow can be controlled and adjusted separately. The sum of the capacity of the fan coil units, which have to function at the same time, results in the total capacity of the chiller unit. Furthermore this system is equipped with a diesel heater, heat exchanger and boiler function. The heat exchanger can be connected to the cooling system of the main engine or generator, for interior or boiler heating. The boiler function can be connected to the diesel heater or heat exchanger, and can function simultanious with the cooling function.
To install the entire unit any cool-technical know-how is not required. A complete system consists out of the chiller unit, fan coil units and thermostats.
|
|
An airco inverter chiller is a system which can be installed in the engine compartment. This chiller unit will control its capacity according to what is being demand in its surroundings due to the applied inverter compressor technology. There is no current peak when switching on the compressor! The chiller unit supplies cold water (glycol) which flows through a tubing circuit and fan coil units, (through which air is pulled at the same time) and as a result it cools the surrounding areas. This system can cool any given area/cabin and the temperature and airflow can be controlled and adjusted separately. The sum of the capacity of the fan coil units, which have to function at the same time, results in the total capacity of the chiller unit. To install the entire unit any cool-technical
know-how is not required. A complete system consists out of the chiller unit, fan coil units and thermostats.
|
|
|
A clima chiller unit is a system which can be installed in the engine compartment. This chiller unit supplies a tubing circuit through the boat with cold or warm water (glycol). This fluid flows through the fan coil units (through which air is flowing at the same time) and as a result it can either cool down or heat up the surrounding areas. This system can control the temperature in any given compartment separately. The sum of the capacity of the fan coil units, which have to function at the same time, results in the total capacity of the clima chiller unit. The integrated diesel heater is the main source for heating the system. In order to install the entire unit any cool-technical know-how is not required. A complete chiller system consists of the clima chiller unit, fan coil units and thermostats.
|
|
The hydraulic driven chiller unit is a system which can be placed in the engine room. This chiller unit is equipped with a hydraulic driven cool compressor, circulation pump and sea water pump (intergrated). The system is driven by a hydraulic installation (mostly already present on board) and a battery supply of 24VDC. This chiller unit supplies a tubing circuit through the boat with cold water (glycol).
This fluid flows through the fan coil units (through which air is flowing at the same time) and as a result it cools the surrounding areas. This system can cool any given area, which have to function at the same time, results in the total capacity of the HC chiller unit.
In order to install the entire unit any cool-technical know-how is not required. A complete chiller system consists of the HC chiller unit, fan coil units and thermostats.
|
|
The Micro HPStm (Hybrid Plate System) represents an entirely new kind of marine refrigeration system.
The most significant advancement in marine refrigeration technology in the past 30 years, and winner of the 2003 NMMA Innovation Award, the Micro HPS blurs the line between small, hermetically sealed DC constant-cycle units and large, high-powered DC holding plate systems. The result is a clean, compact, reliable system of unprecedented power and performance.
|
|
| ... products without information |
| |
|
|
|
|
|
WAECO ColdMachine – maßgeschneiderte Kühllösungen für alle Einsatzzwecke
Wenn Standardgeräte nicht passen, muss individueller Kühlraum geschaffen werden. Dazu sind WAECO ColdMachine Kühlaggregate da. Dank vorgefülltem Kältemittel und selbstdichtender Ventilkupplungen eignen sie sich bestens für den Selbsteinbau. Sie stehen in drei verschiedenen Serien zur Verfügung, um jedem Anwendungsfall gerecht zu werden. ColdMachine Kühlaggregate arbeiten mit leistungsgeregelten Danfoss BDF-Kompressoren. Sie sind leistungsstark, sparsam, superleise, schräglagenunabhängig, anschlussfertig für 12/24 Volt DC. Die als Ergänzung angebotenen Verdampfer wurden optimal auf die jeweilige Kompressorleistung abgestimmt.
Leistungsangepasste Kompressoren
Jedes Kühlsystem besteht aus Kompressor, Kondensator und Verdampfer. Damit es effektiv arbeiten kann, müssen die drei Hauptkomponenten perfekt miteinander harmonieren. So sind im WAECO Programm viele unterschiedliche Kondensatoren und Verdampfer zu finden, die hier optimale Zusammenstellungen ermöglichen.
|
|
|
Danfoss compressor of the latest generation. Extremely compact dimensions. Maximum efficiency. Electrical consumption 25% lower compared to other compressor concepts...
|
|
|
Water cooling with pump saves more than 20% compared to air cooling. Self priming pump reliable and very quiet. Protected against lack of cooling water...
|
|
Cooling unit (12-24-42 Volt DC automatic), fan cooled, for fridge boxes up to 450 litres, freezers up to 300 litres and combined up to 375 litres.
It employs a smart compressor GD30 FDC, by ACC (EX-ELECTROLUX), programmable manually or in "SmartSpeed", fitting automatically the speed according to the need of cold.
Available with tubes to braze or different kind of couplings.
Equipped with increased condenser (TROPIK version) for hard working conditions.
|
|
PRO-HOR30
Cooling unit (12-24-42 Volt DC automatic), fan cooled, for fridge boxes up to 450 litres, freezers up to 300 litres and combined up to 375 litres.
It employs a smart compressor GD30 FDC, by ACC (EX-ELECTROLUX), programmable manually or in "SmartSpeed", fitting automatically the speed according to the need of cold.
Available with tubes to braze or different kind of couplings.
Equipped with increased condenser (TROPIK version) for hard working conditions.
|
|
Cooling unit (12-24-42 Volt DC automatic), fan cooled, for fridge boxes up to 450 litres, freezers up to 300 litres and combined up to 375 litres.
It employs a smart compressor GD30 FDC, by ACC (EX-ELECTROLUX), programmable manually or in "SmartSpeed", fitting automatically the speed according to the need of cold.
Available with tubes to braze or different kind of couplings.
Equipped with increased condenser (TROPIK version) for hard working conditions.
|
|
For refrigerated compartments up to
250 l max. (freezers 100 l max.).
Danfoss BD35F compressor
with fully integrated control
unit (power 12/24V with automatic
switchover).
Air ventilation condenser cooling
unit. 2-row condenser coil with fins.
|
|
Water-cooled units
The range is completed by watercooled
units, which are suited for
marine use in areas with little
ventilation. The unit is cooled
through forced circulation of water
by an optional pump (see photo).
For refrigerated compartments up
to 250 l max. (freezers 100 l max.).
Danfoss BD35F compressor
with fully integrated control
unit (power 12/24V with automatic
switchover).
Corrosion-proof condenser,
cooled by seawater.
12V or 24V
|
|
For refrigerated compartments
up to 250 l max.
(freezers 100 l max.).
Danfoss BD35F compressor
with fully integrated control
unit (power 12/24V with automatic
switchover).
Air ventilation condenser cooling
unit. 2-row condenser coil with fins.
|
|
For refrigerated compartments up
to 250 l max. (freezers 120 l max.).
Danfoss BD35F compressor
with fully integrated control
unit (power 12/24V with automatic
switchover).
Air ventilation condenser cooling
unit. Wire condenser coil.
|
|
For refrigerated compartments up to
250 l max. (freezers 100 l max.).
Danfoss BD35F compressor
with fully integrated control
unit (power 12/24V with automatic
switchover).
Air ventilation condenser cooling
unit. 2-row condenser coil with fins.
|
|
The Micro HPStm (Hybrid Plate System) represents an entirely new kind of marine refrigeration system.
The most significant advancement in marine refrigeration technology in the past 30 years, and winner of the 2003 NMMA Innovation Award, the Micro HPS blurs the line between small, hermetically sealed DC constant-cycle units and large, high-powered DC holding plate systems. The result is a clean, compact, reliable system of unprecedented power and performance.
|
|
|
Indel Webasto Marine provides a wide range of high-quality cooling units to suit every demand. Compact or using the Automatic Start Up (ASU) technology, our Isotherm cooling units are an efficient solution for fridge or freeze use.
|
|
| ... products without information |
| |
| ... products without information |
| |
| ... products without information |
| |
|
|
