Overheating sensors

P. 5
to be inserted through the hole from outside the board fixed two holding springs b note b b do not cover the interior exterior light body any kind temperature isolating material b b the interior exterior light is protected temperature sensor against overheating when the temperature the interior exterior light

P. 5
the interior exterior light is protected temperature sensor against overheating when the temperature the interior exterior light exceeds 85 c the interior exterior light is automatically switched off b 5

P. 6
the installation have to be realized qualified personnel m8 nut m24 note b avoid using the underwater light out the water more than 5 minutes b b the underwater light is protected temperature sensor against overheating when the temperature the underwater light exceeds 60 b b c b b the power supply unit starts

P. 3
the underwater light is recomended to be installed around 02 m below the waterline the best illumination to avoid overheating do not try to install remove the underwater light while the vessel is the water the optical window has to be cleaned soft brush cloth avoid using any abrasive chemical cleaner the optical

P. 8
colour light 1 brown led1 b tl b blue led1 b o o b orange led2 4 violette led2 5 yellow led3 6 green led3 7 red temperature sensor 8 black temperature sensor remote control connection remote control optional can be connected to the control terminalblock connector to turnon turnoff to control

P. 5
light out the water more than 5 minutes b b the underwater light is protected temperature sensor against overheating when the temperature the underwater light exceeds 65 c the underwater light is automatically switched off b hull preparation the underwater light is recommended to be installed around 02

P. 3
the underwater light is recomended to be installed around 02 m below the waterline the best illumination to avoid overheating do not try to install remove the underwater light while the vessel is the water the optical window has to be cleaned mild soap detergent lukewarm water using soft cloth sponge do not use

P. 5
minutes b b the underwater light is protected temperature sensor against overheating when the temperature the underwater light exceeds 65 c the underwater light is automatically switched off b hull preparation the underwater light is recommended to be installee around 02 m below the waterline the best

P. 3
to be installee around 02 m below the waterline the best illumination to avoid overheating do not try to install remove the underwater light while the vessel is the water the optical window has to be cleaned mild soap detergent lukewarm water using soft cloth sponge do not use abrasive highly alkaline cleaners