|
|
F31-0700
TACO’s deck mount style rod holders have the same welded pin design as weld-ons. Ideal for leaning post applications.
|
|
- Chrome Plated Zinc Alloy Flange
- Angled Flush Mount (Approximately 65°)
- Anodized Aluminum Tube
- Soft Black Liner
- Flange Gasket with Integral Flip-Up Cap
- D01 & DPD - Includes a Drain Bib or 5/8 Inch I.D. Flexible Hose
|
|
The Tournament Series Rod Holders feature a 2" or 2 1/4" investment
cast 316L stainless steel top securely welded to a closed end stainless
tube that features a drilled and tapped hole to accomodate a drain fitting.
Also available in economy model with open end.
|
|
|
Feature unique mounting clip for easy installation. Tapered, enclosed bottom. Drilled and tapped. Can accommodate any deck thickness. Easy assembly from deck.
|
|
| ... products without information |
| |
Use this Davis accessory to clip your fenders to rails, lifelines, side wing windows or cleats. Fender Tender II simplifies the handling and relocation of boat fenders. The "Railing Lock" firmly grasps rails from 7/8" to 1" (22 to 25 mm) diameter. New "Lifeline Lock" provides added safety. Use 1/4" to 3/8" (6 mm to 9 mm) diameter nylon line. Made of tough, sun-resistant plastic.
|
|
|
A real piece of gear - Superior quality throughout - made of heavy-gauge stainless steel. It's by far the sturdiest unit available-bar none! It's sleek, slim design provides 2" to 3" less protrusion into the deck area than other models and adjusts to any rake [right, left or vertical]. Collapses easily for off-season storage. Shipped complete with all hardware-no added mounting brackets to buy. Mounts easily on 7/8" or 1" diameter rail or may be deck mounted with holes provided.
|
|
Now available in two sizes. To suit two 200mm or two 240mm fenders. Stainless Steel - Marine Grade - 19mm diameter tube. Bright polished finish. Adjusts to various angles. Simply rivet or screw in position to bulkhead or rails.
Dixon 8" Fender Holder
Adjusts to various angles. Fit to bulk-head or rails. Holds 2 x 8" fender.
|
|
|
|
|
|
|
FENDEQUIP FENDERCOVERS AVAILABLE TO FIT ANCHOR MARINE FENDERS
"The, must have, essential accessory for boats of all sizes including super yachts."
The surface of modern hard plastic fenders traps grit and dirt between the fender and topside.
The constant rubbing of bare fenders on the topsides will cause significant damage to the gel coat of your boat, which is normally very costly to repair.
Fendequip fender covers are specially designed to protect the topsides from fender scuff and reduce the need for expensive gel coat repairs. They are made from a premium stain resistant, non-abrasive, loop-knit acrylic fabric, which is both durable and fade resistant. They are available in a variety of colours and sizes to suit your individual requirements.
Fendequip fender covers will also protect your fenders from dirt and UV and will make your boat look clean and smart. Fendequip fender covers are the, must have, essential accessory for boats of all sizes including superyachts.
Colours: Standard colours throughout the Fendequip range are Navy Blue, Royal Blue, Black and Red. Or a special colour of your choice may be matched, when you place your order, at a minimal extra cost.
|
|
| ... products without information |
| |
|
|
see the results for the following category : 
