|
|
Built Tough Enough to Last a Lifetime. A durable aluminum and anodized frame backed by a tri-lens reflector with a 6 degree beam angle and tempered glass lens light up anything in your path. A double sealed mechanical switch and 8 hour burn time gives intense light dispersion to a max depth of 650 feet.
- Tempered glass lens with Fresnel dome allows more unfiltered light
- Double sealed mechanical switch with Security Lock
- Tri-lens reflector with a 6 degree beam angle
- Minimum 8 hour full power burn time with diminishing output for up to 40 hours
- 10,000 hour lifespan LED bulbs
- Max Operating Depth: 650 ft / 200 meters
- Double O-Ring Seals
- 300 lumens / 5500 degrees kelvin
|
|
|
|
|
|
|
FLASH LED
The heart of the Flash flashlight is a revolutionary LED made up of 4 elements, grouped together in a single PCB, protected by a lenticular dome face in silicon.
The result is a flashlight with an illumination capacity above 6000 Lux with a heat temperature of 6200º Kelvin.
The LED is driven by special electronics that guarantee lighting consistency over time.
This is all assembled on an aluminium frame and sealed with a special resin that makes the LED group (LED, electronics and parabola) perfectly water-tight.
In fact, if the flashlight accidentally flashlight fills with water, the LED group will not be damaged and, after rinsing with fresh water, and drying, it can be used as if it were new. In this case, only the batteries are damaged and must be replaced.
The recall spring can be removed so the flashlight can be kept in the On position, and the switch can be then held in this position thanks to the special safety catch.
The Flashlight is powered by 6 AA 1.5V batteries, Energizer Lithium are supplied with the flashlight, that allow for a range of 120 minutes of constant use and 300 minutes of intermittent use with 60 seconds ON/60 seconds OFF.
Size: Length 195mm x Diameter 59mm Weight in air with 6 Lithium batteries = 390g.
Weight in water with 6 Lithium batteries = 230g.
|
|
|
Nova is a lightweight, compact dive light that provides up to eight hours of high-intensity light from an LED bulb. It is bright enough to be used as a primary light, and compact enough to be used as a backup.
|
|
Infinite light.
X-Led stands apart for its high autonomy, its reliability, and sturdiness thanks to its body in anodized aluminum alloy. In order to allow an easier grip, a practical metal handle is available as an optional.
|
|
|
The most recent model among the Moonlight series of flashlights, Moonlight Led features a 3 Watt Led bulb that produces a very powerful and concentrated light beam with a power of 5.500 °K. The performance of the resulting beam is comparable to the one produced by a standard 10W bulb. Burn time is high: 30 hours with 6 non rechargeable batteries (included). The head of the flashlight features a new design and made in alluminum with a rubber protective cover.
|
|
Extremely small flashlight powered by four AA alkaline batteries with a 5W bulb. Burning time is around 1.5hrs. Minimicra features an exclusive quick release mechanism to carry the flashlight on the belt, and operates with just one hand.
|
|
Nemo™ 4300
Big brother to the 4200, the Nemo 4300 is the ultimate dive light. The 4300 has an unbreakable ABS body with thermoplastic over-moulded accents and polycarbonate lens. It uses a clever magnetic switch that operates outside of the body to prevent leaking. The switch can be easily removed for washing off sand and dirt. Peli's unique battery compartment design allows for optimal space utilization and negative buoyancy. A spare Xenon lamp is included and stored underneath the reflector. Submersible to 150 meters and powered by 8 C alkaline cells.
|
|
Small wonder. Small and lightweight, the Hybeam is the perfect all-purpose waterproof light for your BC pocket, dive bag, boat, car, or tent. It packs a six-watt punch with just four included AA alkaline cells, and comes with a halogen bulb and wrist lanyard.
1.5 hour burn time with 4 AA batteries
Halogen bulb
6 watts
Trigger lock ensures the light won't accidentally turn on
Double o-ring seal waterproof to 200 feet
Batteries and wrist lanyard included
|
|
|
Compact light with halogen bulb 3.5 watt, with locking switch. Double oring seal to insure a leak proof seal. Shipped lanyard. Operating depth 500ft. Uses 3 size C batteries of 1.5 volts.
|
|
|
Day or night a dive light is an essential piece of dive equipment. The Aeris Vision 4C Light is designed to be compact, yet extremely powerful.
|
|
|
Compact and light torch, very strong and completely waterproof even at the maximum depth thanks to the double o-ring seal on the lens cover and the magnetic switch, which eliminates any possible water seepage even after years of use.
|
|
The simplest solution to illuminate your dive
Simplicity in design is what characterizes this reliable and compact model.
|
|
|
|
|
|
|
New dive light that brings greater burn-time to the NiMH battery technology than the Accus Ni-Cad version.
General characteristics :
- Marine-quality anodized aluminum alloy body.
- Screwed reflector block for access to the bulb, the reflector, and the charging outlet.
- NiMH 12 V/ 4.3 Ah accumulator
- 30 W high-luminosity halogen light bulb G 6.35
Temperature at heat source 3200 °C
750 lumen light flux
- 50 W HLX high-luminosity halogen light bulb G 6.35
Temperature at heat source 3300 °C
1600 lumen light flux
- High-efficiency magnetic switch.
- Electronic control switch for turning on the bulb.
- Electronic control system for battery discharge that avoids "memory effect" phenomena and guarantees a maximum of charge/discharge cycles.
- Flashing red light notifies the diver that batteries are on "reserve".
- Fast, "intelligent" battery charger specific for NiMH (115 V/230 V) that permanently controls the status of the battery before and during continuous current charging in a maximum of 3 hours.
- Automatic charging halt before switching to "maintenance current" mode.
- Option for partial charging without complete discharge, to prolong the life of the batteries .
- Power light for the battery charger.
- Rechargeable thermal protection through battery charger.
- Case provided.
- Handle with white ergonomic grip.
- Front shock protection
- Padded transport bag
- Provided with 30 W light bulb and 50 W light bulb
- Burn time: 50 W à 60 min. - 30 W à 1 H 40 min.
|
|
| ... products without information |
| |
- Allround signalling light in different colours for general warning purposes
- Seawater resistant
|
|
Main body of corrosion resistant (seawater) light alloy. Yellow polyurethane paint.
Globe of impact resistant polyamide available in colours red, blue, amber, clear or green.
Approved according to CENELEC EN50014, 50018.
|
|
Luminaire Emergency
Tranberg luminaires are all designed for use in rough environments. It is the policy of Tranberg to provide products and services that meet the highest standards of quality in the industry and the performance needs and expectations of our customers. the design of Tranberg luminaires is based on many years of experience and extensive research in the field of professional Marine lighting. Carefully selected materials are used to ensure maximum performance, low maintenance and a long trouble free life.
|
|
EEx de IIB T5 Ex II 2 G
For use in Zone : Zone 1, Zone 2
Tranberg luminaires are all designed for use in rough environments.
The helideck light system delivered by Tranberg is designed to meet
the toughest conditions in the helicopter landing areas. The floodlights
are designed to provide adequate illumination of the whole area without
glare to pilots or helicopter personnel in the area. Helideck equipment
manufactured by Tranberg is delivered to offshore installations, oil
tankers and supply ships, hotels and hospitals all over the world.
|
|
Easy to change safety glass lens.
No tools required for relamping.
Terminal block for incoming wiring.
Corrosion resistant stainless steel deep drawn seamless housing.
Epoxy powder coated finish.
Highly polished aluminum wide beam reflector.
Stainless steel hardware.
|
|
Class 1, Division 2, Groups A,B,C,D, T1.
Class 1, Zone 2, Group II, T1.
Easy to change safety glass lens.
No tools required for relamping.
Terminal block for incoming wiring.
Corrosion resistant stainless steel deep drawn seamless housing.
Epoxy powder coated finish.
|
|
Easy to change safety glass lens.
No tools required for relamping.
Terminal block for incoming wiring.
Corrosion resistant stainless steel deep drawn seamless housing.
Epoxy powder coated finish.
Highly polished aluminum wide or narrow beam reflector.
Stainless steel hardware.
|
|
|
|
see the results for the following category : 
