Console covers

P. 2
Model Year 2011 Specifi ed measurements are approximations and subject to variance. VHF RADIO ? Raymarine Ray49 VHF ALUMINUM TRAILER ? Disc brakes ? Guide on stanchions ? LED lights ? Radial tires ? Spare tire ? Torsion axle CANVAS ? Console cover (black or blue) ? Leaning post

P. 1
rod holders (4) ? Heavy-duty rub rail ? Motorwell drains (2) ? Self-bailing cockpit sole ? Stainless steel grab rails ? Stainless steel bow rail ? Fiberglass swim platform with grab rail and telescoping stainless steel swim ladder CONSOLE ? Acrylic windshield ? Compass ? Courtesy lights (2

P. 2
? Console cover (black or blue) ? Reversible pilot seat cover (black or blue) ? Sun top with boot (black or blue) and stainless steel fi ttings 180 DAUNTLESS® SPECIFICATIONS

P. 1
? Bow trolling motor fl at ? Drink holders forward (2) ? Full-width aft casting platform ? Stern deck mounted stainless steel rod holders (2) ? Heavy-duty rub rail ? Aft side rails ? Stainless steel bow rail ? Integral swim platform with telescoping ladder CONSOLE ? Acrylic windshield ? Drain

P. 3
modern spacious interior sleeping four people three quarter open deck space covered esthec further full bar popup jacuzzi proved to be the winning combination

P. 4
-bar with navigation lights . self-righting frame with navigation lights . consoles and seats configurations . DURARIB? foam collar . lifting sling . overall cover . foot straps . console cover . additional fuel tank . electronics packages

P. 27
is ready for operation - Open inspection cover at the measuring head. After about 15 seconds the green READY LED and LED No. 1 turn off simultaneously. LED No. 14 is blinking ( meaning: negative pressure in the measuring compartment is too low ) - Close inspection cover at the measuring head

P. 25
Performance Test Attention The engine is uncontrolled during this performance test! A performance test of the device without an alarm being indicated externally can be carried out as follows: - Open the cover of the measuring head casing - Wait until the READY LED is switched

P. 31
Failure LED No. 14 is blinking - negative pressure in the measuring head too low. Possible causes: Open inspection cover Filter or water separator in the air supply pipe clogged or filled Pressure reducer misadjusted by vibration Pressure restrictor misadjusted by vibration Sintered

P. 18
inspection cover. ( See Fig. 3. 01 / 1 ) ( Pressure gauge is included in the service box, available as an option ) 2. Loosen nut (1) and turn setscrew (2) in clockwise direction gently up to the stop. 3. Open safety cover ( 3 ) at the throttle ( 5 ) and manually turn setscrew ( 4 ) in clockwise direction

P. 17
operation Device in operation: green READY LED on, contacts 4 and 5 closed, contacts 3 and 5 open Device faulty: green READY LED off, contacts 3 and 5 closed contacts 4 and 5 open 24 V DC 25%, maximum 3 A 2 A with semi time-lag 4 A with semi time-lag Heating system Alarm relay Resistor for wire