|
|
The charge regulator CRM is especially suitable for marine applications. It is completely sealed and thus effectively protected against the marine environment.
The regulator has two separate outputs, which can be used to charge two battery sets separately (eg. starter battery and service battery on a yacht). The two outputs can be connected together if only a single battery shall be charged. More than two separate battery sets are charged by wiring additional diode units between the batteries. For adaption to different types of batteries the charging voltage can be adjusted in a range of +/- 20 %
|
|
The CR30W is a sophisticated charge regulator for 12 V or 24 V DC small wind applications based on a special micro-controller.
The regulation is done by a shunt load (power resistors) which is switched by the regulator to prevent overcharging. Therefore the wind generator can be connected directly to the battery and never runs unloaded.
The micro controller together with a smart electronic circuit provides high-efficiency charging technology combined with a reduction in the number of electronic components. Therefore excellent battery treatment is now available at reasonable cost and with outstanding reliability even at tough environmental conditions.
|
|
The C40 has long been the mainstay of our charge controller line-up, its versatility and reliability have made it an industry standard. Now the C40 is joined by two companion controllers, the C35 and C60.
|
|
| ... products without information |
| |
The C40 has long been the mainstay of our charge controller line-up, its versatility and reliability have made it an industry standard. Now the C40 is joined by two companion controllers, the C35 and C60.
|
|
| ... products without information |
| |
|
|
