Boats latches

P. 5
Add triangular part (G2) to this, fixing with black, spherical knob (G1). Put screw of each rib into the hole and close the latch. Insert material into grooves of bars F5 and F6 at rear of canoe. 5

P. 6
Fix bar F6 ( rear left of canoe) on the rib C6.5 and fix bar F4 on rib C 6 Put seats (H2 and H3) into place, securing with black knob (H1), then backrests (H4,H5, H6) Inflate hull, being careful not to overinflate, then put the small plastic plugs into the ends of the tubes. 6

P. 4
strips to the outside ( F1 to F6), slide onto the upper edge of the hull material. Take the longer bars and slide from rib C6 towards front of canoe, slotting material into the grooves, left and right sides consecutively. Fix bars (F1 and F2 ) to the top of rib B2 as in photo. 4

P. 3
Assemble the rear part (A2) in the same way, replacing ribs 1 and 2 with n° 6, and 7, (C6, C7). Attach s poles with hooks (2x E4) then the two longer poles(2xE3) Rib C6.5 – concerns TROJAK only Unfold the hull (material) of the canoe. Slide the front and rear parts of the structure

P. 12
which can appear under lower deck floor. 8. Upper deck cleaning perform by light sweeping if required. 9. It is necessary to clean and dry kayak before packing back to the bags. To dry the hull it is required to pour out the water then sweep and assure air access by locating one rib into both front and rear

P. 5
Add triangular part (G2) to this, fixing with black, spherical knob (G1). Put screw of each rib into the hole and close the latch. Insert material into grooves of bars F5 and F6 at rear of canoe. 5

P. 6
Fix bar F6 ( rear left of canoe) on the rib C6.5 and fix bar F4 on rib C 6 Put seats (H2 and H3) into place, securing with black knob (H1), then backrests (H4,H5, H6) Inflate hull, being careful not to overinflate, then put the small plastic plugs into the ends of the tubes. 6

P. 4
strips to the outside ( F1 to F6), slide onto the upper edge of the hull material. Take the longer bars and slide from rib C6 towards front of canoe, slotting material into the grooves, left and right sides consecutively. Fix bars (F1 and F2 ) to the top of rib B2 as in photo. 4

P. 3
Assemble the rear part (A2) in the same way, replacing ribs 1 and 2 with n° 6, and 7, (C6, C7). Attach s poles with hooks (2x E4) then the two longer poles(2xE3) Rib C6.5 – concerns TROJAK only Unfold the hull (material) of the canoe. Slide the front and rear parts of the structure

P. 12
which can appear under lower deck floor. 8. Upper deck cleaning perform by light sweeping if required. 9. It is necessary to clean and dry kayak before packing back to the bags. To dry the hull it is required to pour out the water then sweep and assure air access by locating one rib into both front and rear

P. 72
Furniture Catch lock Bungee cord chair latching Metal chair latching 06_10 engl. Similar to image

P. 2
R&M Product Catalogue Wall Systems Ceiling Systems Floor Systems Marine Doors Marine Furniture Marine Cabins Wet Units Others

P. 156
marine cabins_2010.qxp:marina cabins 01.06.2010 21:09 Uhr Seite 3 R&M Marine Cabins Passenger cabin Crew cabin Prefabricated cabins – key data Passenger and crew cabins to meet individual standards Technical Stable, welded base frames Finishes Stainless steel finish or PVC foil finish

P. 55
marine doors_2010.qxp:marine doors 26.05.2010 8:22 Uhr Seite 1 R&M Marine Doors Practical: R&M Marine Doors We differentiate between doors installed like wall elements and clamping frame doors that are attached in the required position to a two-part frame, which can also be installed later on. Two

P. 59
marine doors_2010.qxp:marine doors 01.06.2010 20:58 Uhr Seite 7 Cabin door with clamping frame – Product Range Door without fixtures Door with ventilation grid Similar to image Cabin door with clamping frame Similar to image Cabin door with clamping frame Door with emergency exit

P. 12
vertical sliders refer to the table page 6 placement information b wedge lock b b slide b s b latch b yachtsman vertical lift slider j ed oh b 12 b americant b marine x b wwwamericanmarinecom american marine products inc 1790 southwest 13th court pompano beach florida 330694715 tel 954 7821400 fax 954

P. 20
seals b b torpedo guide b b standard latch mobella talon mm9917 b b bulkhead mount b b step mount b b 20 b american 7 b marine x b wwwamericanmarinecom american marine products inc 1790 southwest 13th court pompano beach florida 330694715 tel 954 7821400 fax 954 7821404

P. 19
b i b b sliding entry door b b model 460 b jamb the heavy hollow door frame design helps prevent distortion during installation serves to channel any water entering the latch holes to the drain slots the bottom the fully welded frame thus minimizes water intrusion into the boat window the window

P. 9
b latch stop the b mariner b series the inner glass slider is fitted clamshell latch which firmly locks the sliders the closed position is used as pull to open the slider once position slider stop below the latch is depressed to hold the slider firmly fixed open position preventing movement

P. 14
imron polyurethane paint many color options are available view raised bifold hatch latches air springs b 14 b americant marine x wwwamericanmarinecom american marine products inc 1790 southwest 13th court pompano beach florida 330694715 tel 954 7821400 fax 954 7821404

P. 7
is not only attractive but functional, allowing constant air circulation necessary in marine environments. Positive latch cabinet hardware prevents doors from opening in rough seas, while hinges keep doors ajar until you close them. When the fish have been cleaned, cooked and eaten, and the sun has set, life

P. 33
? Hatches, lazarette and fish boxes, heavy-duty, gasketed, drains, gutters, full-length stainless steel piano hinge and custom latch ? Hose and pistol-grip nozzle ? Icebox, starboard, fitted with gasketed lid, gas spring actuator, full-length stainless steel piano hinge and custom latch ?

P. 45
? Hatches, lazarette and fish boxes, heavy-duty, gasketed, drains, gutters, full-length stainless steel piano hinge and custom latch ? Hose and pistol-grip nozzle ? Icebox, starboard, fitted with gasketed lid, gas spring actuator, full-length stainless steel piano hinge and custom latch ?

P. 27
? Gunwale padding, high-density foam, white vinyl covered ? Hatches, lazarette and fish boxes, heavy-duty, gasketed, drains, gutters, full-length stainless steel piano hinge and custom latch ? Hose and pistol-grip nozzle ? Icebox, starboard, fitted with gasketed lid, gas spring actuator

P. 21
? Fish boxes (2), large capacity, insulated, macerator pump-out system ? Gunwale padding, high-density foam, white vinyl covered ? Hatches, lazarette and fish boxes, heavy-duty, gasketed, drains, gutters, full-length stainless steel piano hinge and custom latch ? Hose and pistol-grip nozzle