|
|
Gulper 320® High Capacity Multi-Purpose Waste Pump
Built on more than a decade of market leading pump technology, the next generation Gulper
• Non-choke valves - no filter to block or clean
• Easy to install - including uneven surfaces
• Only 3 screws to secure
• Secure fit - new wrap around mounting feature
• Head rotates 360 degrees to suit your installation
• Self primes and runs dry
Application A
• High Capacity Waste Pump
- Fast Drainage
– Save space with faster drainage
– Use smaller grey waste tank
– One pump for multiple drains
0R
Application B
• Easy Access Remote Mount Bilge Pump
– Remote mounting allows easy access
– Meets requirement for primary bilge pump for boats up to 12m (39.4ft) length
– Ideal where bilge space is limited
– Long life
0R
Application C
• Fishbox Discharge Pump
– Handles fishbox waste
– Easy to install in convenient locations
|
|
Supersub Smart 650
Narrow Low Profile Automatic Pump with Intelligent Control built in
• Fully automatic bilge water removal
• No separate bilge switch required - water proof electronics
• Protected against capillary action water ingress
Extra long caulked tinned electric wires (2m)
• Automatically Controlled
Patented electric field sensor automatically detects water level
• Quick and easy installation
• Unaffected by wave motion
• Environmentally friendly - mercury free
• Includes manual override facility
• Solid State switching - no moving parts
|
|
|
12 volt submersible bilge pumps are constructed of shock resistant A.B.S. plastic, and powered by the world's best compact motor. The snap-on strainer base makes installation a simple procedure. These reliable pumps are available in four sizes from 500gph to 1000gph.
|
|
|
The best choices when you are looking for high performance, heavy duty pumps designed to meet the tough demands of commercial and recreational duty. Both pumps may be automatically controlled with either an automatic switch AS888 or an electronic float switch or the new Ultima Switch.
|
|
UltimaBilge%u2122 Pumps are the latest addition to the Johnson Pump brand lineup. Integration of the patented Ultima %u201Cfield effect%u201D sensing technology into the bilge pump body creates a sleek, reliable compact, unit ready to install and run for years and years of unerring service.
Available in 600-800-1000-1250 GPH versions. Voltage12 V DC. For UltimaBilge%u2122 600GPH-100GPH, we have easy-to-install Dura-Port discharge ports to eliminate stress cracking caused by over-tightened hose clamps. These pumps will be delivered including both a straight and a 90° smooth elbow Dura-Port.
For UltimaBilge%u2122 1250GPH we include threaded 1.1/4" & 1.1/8" discharge port.
|
|
The both pump series consists of four different sizes. The basic version can be combined with either an automatic switch AS888, an electronic float switch or the new ULTIMA switch for automatic operation. The Cartridge Duo pumps are equipped with a non-clogging electronic float switch as standard.
For L450, L550, and L650 and dito Ultima Combo versions, we have improved the design with easy-to-install Dura-Port discharge ports to eliminate stress cracking caused by over-tightened hose clamps.
The pumps will be delivered including both a straight and a 90° smooth elbow Dura-Port as well as a removable check valve.
|
|
|
A small, price-wise alternative in the submersible bilge family. The low-cost choice for boat owners who do not want to forsake quality.
|
|
The both pump series consists of four different sizes. The basic version can be combined with either an automatic switch AS888, an electronic float switch or the new ULTIMA switch for automatic operation. The Cartridge Duo pumps are equipped with a non-clogging electronic float switch as standard.
For L450, L550, and L650 and dito Ultima Combo versions, we have improved the design with easy-to-install Dura-Port discharge ports to eliminate stress cracking caused by over-tightened hose clamps.
The pumps will be delivered including both a straight and a 90° smooth elbow Dura-Port as well as a removable check valve.
|
|
Gulper® 220
Shower Drain, Waste Water And Bilge Pump
• Pumps waste water with a solid content typical of shower waste
• Non-choke valves
• Self-priming up to 3 m (10 ft)
• Can run dry without damage
• Can pump air / water mixtures
• Robust, reliable design
• Pumps up to 14 ltrs (3.7 US gals) per minute at open flow
• No filter required
• Quiet running
• Multi-directional head allows the pump to be mounted in the most
convenient part of the boat
• Low power consumption
Typical Uses
• Showers and sink drainage
• Baitwell recirculation
• Tank drainage / circulation
|
|
Orca- Electric Bilge Pump Range
Compact and Powerful Electric Bilge Pumps
• High performance
• Simple installation- Multiple wire locations
• Meets ISO8849 marine standard
• Low amp draw means long battery life
• Easy maintenance- Access to motor cartridge and filter area
• Compact design
• Robust ABS fuel-resistant housing
• Large filter base ensures maximum surface area exposed to bilge water
• Available in a range of 3 flow capacities-500, 950 and 1300 GPH
|
|
Gulper® Grouper - Fishbox Discharge Pump
Pumps Specifically Designed To Pump Out Fishbox, Livewell, And Baitwell Waste
• No impeller to clog or burn
• Non-choke valves
• Can run dry without damage
• Pumps air / water mixtures
• Single pump for multiple wells
• Heavy duty single diaphragm
• Easy to maintain and clean
• Up to 25.5 ltrs (6.75 US gals) per minute at open flow
• Low power consumption
• Multi-directional head allows the pump to be mounted in the most convenient part of the baitwell
Typical Uses
• Management of baitwell waste
• Pump out of fishbox
|
|
Super Sub
Electric Bilge Pump Designed For Narrow Bilges
• Low profile design is ideal for narrow bilges
• Two position outlet hose
• Flow up to 1900 ltrs (500 US gals) per hour
• Very low power consumption
• Easy to clean snap fit assembly
• Leaves the bilge almost dry
|
|
Quick bilge pumps are available in eight versions: four automatic units equipped with
two sensors and four manual units.
The distinctive feature of the automatic pump
is that it can be started up automatically when the two sensors, located on the side, come into contacts with a certain quantity of water.
The body of the bilge pumps is made of high quality thermoplastic resin.
The drive shaft, screws and sensors are made of stainless steel.
The drive shaft has a mechanical seal.
|
|
ELECTRIC BILGE PUMPS
The bilge pumps submarines for boats very often function
with a water column of more than one meter.
When you compare them
capacities of the various pumps
of hold, check them
performances without column
of water and with a column
of water of 1.00 Mr. Toutes them
pumps VETUS are famous
in conformity with the standards
ABYC H - 22, of the ISO
Navy 8849 and with the standards
33 CFR, part 183 the US ones
Coast Guard
Safety.
|
|
Attwood’s pumps play no "rating games" like competitive pumps. Attwood electric bilge pumps deliver value and performance that’s built to last.
|
|
Rule's 700 and 750 G.P.H. Pumps offer increased capacity in keeping with it's 3/4" (19mm) discharge outlet. 12 Volts DC unless noted.
|
|
High pumping capacity and reliability at a lower cost. The Rule 1500 offers more pumping capacity and more exclusive design features than any comparable competitive pump. 1-1/8" (28.6mm) discharge outlet. 12 Volts DC unless noted.
|
|
Technical specifications:
Electric motor: three-phase induction motor MEC T63C4 or single-phase induction motor MEC M63C2
Power supply: 230 V / 400 V – 50 Hz depending upon the model
Power output: 0.22 kW / 0.25 kW depending upon the model
Absorbed current: 1.6 A / 1.4 A depending upon the model
Protection rating: IP 55
Condenser: 10 µF
Speed of motor rotation: 1,380 rpm / 2,800 rpm depending upon the model
Maximum pressure: 20 bar
Capacity: ranging from 5 to 22 litres / minute
Data referring to the following test fluid: oil with viscosity n =13 cSt and temperature ranging between 15°C and 20°C
|
|
A very compact, powerful pump which is ideal for the hard life of working boats. This pump can lift up to 130 litres per minute (to free outlet) and is available for 12 and 24 V.
The motor has double roller bearings, and a mechanical seal virtually eliminates shaft wear. This, together with water cooling, helps to ensure many years of trouble free life with very low power consumption.
|
|
|
High pumping capacity and reliability at a lower cost. The Rule 1500 offers more pumping capacity and more exclusive design features than any comparable competitive pump. 1-1/8" (28.6mm) discharge outlet. 12 Volts DC unless noted.
|
|
|
The Rule 500 offers many design features while keeping size and cost to a minimum. Especially popular on smaller craft, Rule 500 pumps are unmatched in pumping power and longevity.
|
|
|
Engineered to commercial standards. The Rule 2000 is the best selling high capacity submersible bilge pump in the world. 1-1/8" (28.6mm) discharge outlet. 12 Volts DC unless noted.
|
|
|
Quality bilge pumps you can trust. SHURflo’s bilge pumps are built for the harsh marine environment to withstand the toughest conditions. Standard with 3’ Tinned Wire Assembly for above waterline installations and water cooled motors for extended life. .
|
|
Self-priming diaphragm pump with 12v or 24v DC electric motor. Flow rates up to 18.9 litres/min (5 US gallons/min)
Features:
Self-primes up to 10ft (3m) vertical lift
Runs dry without damage to the pump
Quick-connect plug-in ports for easy installation
Includes strainer, 3/4" hose barb and 3/4" garden hose ports
|
|
|
|
see the results for the following category : 
