|
|
The CR30W is a sophisticated charge regulator for 12 V or 24 V DC small wind applications based on a special micro-controller.
The regulation is done by a shunt load (power resistors) which is switched by the regulator to prevent overcharging. Therefore the wind generator can be connected directly to the battery and never runs unloaded.
The micro controller together with a smart electronic circuit provides high-efficiency charging technology combined with a reduction in the number of electronic components. Therefore excellent battery treatment is now available at reasonable cost and with outstanding reliability even at tough environmental conditions.
|
|
The charge regulator CRM is especially suitable for marine applications. It is completely sealed and thus effectively protected against the marine environment.
The regulator has two separate outputs, which can be used to charge two battery sets separately (eg. starter battery and service battery on a yacht). The two outputs can be connected together if only a single battery shall be charged. More than two separate battery sets are charged by wiring additional diode units between the batteries. For adaption to different types of batteries the charging voltage can be adjusted in a range of +/- 20 %
|
|
Intelligent Battery Chargers
The IC Series Intelligent Battery chargers offer an ideal way of charging any type of lead acid battery safely and reliably.
The rugged fully protected unit (IP67) can be used in a variety of applications including on trucks, off road vehicles, fire vehicles, boats, caravans and in depots and workshops.
|
|
The Alfatronix IC Series is suitable for charging all types of lead acid batteries using a 3 stage system. They are enclosed in a rugged, anodized aluminium extrusion and sealed to IP67 and can be installed practically anywhere on boats or vehicles, on road or off and at depots or garages.
These battery chargers offer an ideal solution where a compact charger is required to operate in hostile environments.
|
|
Install Mastervolt battery chargers and rest assured that your on board batteries are always quickly and completely charged, even when you have limited supply or are moored in marinas with low shore power.
Mastervolt's three-step charging method guarantees optimum efficiency. Your batteries will perform better and last much longer.
|
|
Important advantages:
- Multiple outputs in order to charge more groups of batteries (internal battery isolator diodes).
- Charge selector for liquid/gel electrolyte batteries.
- Low residual fluctuation on output (ripple lower than 30 mV RMS).
- Compatible with every kind of generator.
- Can work in a wide range of ambient temperatures.
3 Step automatic charge:
BULK phase (constant current)
ABSORPTION phase (constant voltage)
FLOAT phase (maintenance)
Universal AC Network: models DR
Protections:
- Reverse polarity (with internal fuse)
- Overload
- Output short circuit
- Overheating
|
|
Important advantages:
- Multiple outputs in order to charge more groups of batteries (internal battery isolator diodes).
- Charge selector for liquid/gel electrolyte batteries.
- Low residual fluctuation on output (ripple lower than 30 mV RMS).
- Compatible with every kind of generator.
- Can work in a wide range of ambient temperatures.
3 Step automatic charge:
BULK phase (constant current)
ABSORPTION phase (constant voltage)
FLOAT phase (maintenance)
Universal AC Network: models DR
Protections:
- Reverse polarity (with internal fuse)
- Overload
- Output short circuit
- Overheating
|
|
Important advantages:
- Multiple outputs in order to charge more groups of batteries (internal battery isolator diodes).
- Charge selector for liquid/gel electrolyte batteries.
- Low residual fluctuation on output (ripple lower than 30 mV RMS).
- Compatible with every kind of generator.
- Can work in a wide range of ambient temperatures.
3 Step automatic charge:
BULK phase (constant current)
ABSORPTION phase (constant voltage)
FLOAT phase (maintenance)
Universal AC Network: models DR
Protections:
- Reverse polarity (with internal fuse)
- Overload
- Output short circuit
- Overheating
|
|
Important advantages:
- Multiple outputs in order to charge more groups of batteries (internal battery isolator diodes).
- Charge selector for liquid/gel electrolyte batteries.
- Low residual fluctuation on output (ripple lower than 30 mV RMS).
- Compatible with every kind of generator.
- Can work in a wide range of ambient temperatures.
3 Step automatic charge:
BULK phase (constant current)
ABSORPTION phase (constant voltage)
FLOAT phase (maintenance)
Universal AC Network: models DR
Protections:
- Reverse polarity (with internal fuse)
- Overload
- Output short circuit
- Overheating
|
|
Important advantages:
- Multiple outputs in order to charge more groups of batteries (internal battery isolator diodes).
- Charge selector for liquid/gel electrolyte batteries.
- Low residual fluctuation on output (ripple lower than 30 mV RMS).
- Compatible with every kind of generator.
- Can work in a wide range of ambient temperatures.
3 Step automatic charge
BULK phase (constant current)
ABSORPTION phase (constant voltage)
FLOAT phase (maintenance)
Universal AC Network: models DR
Protections:
- Reverse polarity (with internal fuse)
- Overload
- Output short circuit
- Overheating
|
|
Battery chargers/charging converters – always a full battery
Starter batteries and leisure batteries are designed for different tasks. Starter batteries, in order to start the engine, must initially supply a high current level and will then serve as an energy buffer with smaller partial cycles. Supply or leisure batteries, by contrast, are charged and discharged at lower current levels for longer periods of time, which means they are subjected to significantly higher loads. Correct charging is the key to success. With a complete range of IU- and IU0U battery chargers, WAECO offers optimum charging technology for gel and AGM supply batteries. In each case, the consumed battery capacity should be replaced by a full battery charge. Even after longer journeys, with additional charge from the generator, the battery should immediately be connected to the power supply! Alternatively, you can use a PerfectCharge IU charging converter. These units guarantee optimal charging during the drive. How powerful a battery charger has to be depends on the battery capacity. As a rule of thumb, the charging current of the battery charger should be at least 10% of the battery capacity.
|
|
When setting up the battery part of your 12 or 24V system, the required capacity and battery type are not the only things you need to consider: the vital components around the battery are at least as important for the charge current supply, ease of maintenance and extra safety.
Mastervolt provides you with all the necessary high quality items to perfectly round off your installation, guaranteed worldwide.
|
|
Dolphin Battery Chargers (available from 12v10a - 24v400a) provide a reliable, stress free way to charge batteries. They are compatible with all types of generators currently available on the market.
Your Dolphin Battery Charger has an automatic 115V/230V switchover (except 12v10a & 12v15a) meaning that your charger is always compatible with shore power. Acceptable voltage range is 98 - 130 Volts and 195 - 265 Volts. Regardless of the quality of shore power (weak shore power supply in high summer) your DOLPHIN 2 will work efficiently.
Sturdy & reliable, there are 6 charging programmes suitable for all common types of marine batteries. In addition, there are 2 winterising programmes, 1 sulphation recovery programme & 1 power supply programme. This latter function is very practical for certain on board instruments or for guaranteeing a constant & efficient illumination whilst prolonging the life of the light bulb.
Many internationally renowned boat builders like Beneteau/Jeanneau and Azimut are proud to have Dolphin Battery Chargers as part of their on board system.
|
|
The new Centaur range of battery chargers from Victron Energy have been designed to be a true world-wide product. Universal compliance and input/output specifications are cornerstone characteristics of the new range from the established Dutch manufacturer.
Designed to meet the requirements of both CE for Europe and UL for the United States, the Centaur model range features auto-ranging input covering 90-265Vac 50/60Hz input meaning they can be used anywhere in the world. Crucially, and unlike other products that state universal input, the Centaur range will maintain full output power within the entire specified range.
|
|
Xantrex TRUECHARGE RV
Quick battery charging and safer DC power distribution for RVs. XantrexTM TRUECHARGETM RV is the perfect DC power source for the most demanding RVs.
|
|
Truecharge 20+ & 40+ (90-135 VAC)
Truecharge multistage battery chargers are microprocessor controlled for fast and accurate charging of all deep-cycle ‘house’ batteries. A wide AC input voltage range enables proper delivery of a full three-stage charge, even when charging from less than perfect quality shorepower or generator power.
|
|
Unlike classic battery isolators with diodes, electronic isolators make it possible to have a very low drop between the alternator voltage level and that of the battery.
The higher the current is, the higher the voltage drop will be. The voltage drop reached, for 150A, on one channel, 90mV typ. / 120mV max (measured while warm).
At the end of the charging cycle, the current diminishes. The voltage drop becomes very weak (only a couple of mV), the batteries are thus optimally charged without having to modify the regulation circuit of the alternator.
During charging, the 150a isolator acts as a resistor of less than 1mOhm or the equivalent of a copper wire of 16mm² with a length of 1m.
Likewise, thanks to the low voltage drop, power losses are reduced thus increasing the global output of the charging circuit and reducing the heat to be vented. This diminishes the battery charging time (upon condition that the losses via the cables are negligible).
|
|
The DC WhisperGen™ heat and power system is a uniquely quiet, independent power generation and heating system adapted for the marine sector, mobile, and remote home environments.
It provides power to automatically charge batteries that run all of the onboard / remote applications anytime.
It automatically provides hot water and also heat for a warm and dry living environment inside.
|
|
The C40 has long been the mainstay of our charge controller line-up, its versatility and reliability have made it an industry standard. Now the C40 is joined by two companion controllers, the C35 and C60.
|
|
All features of a sine wave inverter and charger in one compact enclosure.
UPS functionality: seamless transfer from external AC to inverter supply.
A unique AC power management system will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery: where peak power is often required only for a limited period, the Phoenix MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery.
|
|
| ... products without information |
| |
|
|
