Antifouling thinners

P. 1
on the actual dry film thickness, the nature of the substrate, and the relevant consumption factor. The physical constants are subject to normal manufacturing tolerances. Application Details: Application method: Brush Conventional spray Airless spray Roller Thinner: FLAG Antifouling Thinners Cleaning of

P. 1
manufacturing tolerances. Application Details: Application method: Brush Conventional spray Airless spray Roller Thinner: FLAG Antifouling Thinners Cleaning of tools: FLAG Antifouling Thinners Surface condition: The surface should be stable, firm, dry and free of dust, sand, loose old paint, dirt, grease

P. 1
. The physical constants are subject to normal manufacturing tolerances. Application Details: Application method: Brush, Conventional spray, Airless spray, Roller. Thinner: FLAG Antifouling Thinners Cleaning of tools: FLAG Antifouling Thinners Surface condition: The surface should be stable, firm, dry

P. 1
. Airless spray. Thinner: FLAG Antifouling Thinners Cleaning of tools: FLAG Antifouling Thinners Surface condition: The surface should be smooth, stable, firm, dry and free of dust, sand, loose old paint, dirt, grease, oil and salt. Please refer to the Material Safety Data Sheet for further information

P. 39
for the Gummipaint range. Thinner 6380, when added to Gummipaint and Gummipaint A/F enables spray application, but is also suitable for brush application. Diluente 6470, thinner for antifoulings/one-pack paints. Diluente 6470 is the recommended thinner for all antifouling paints from Veneziani as well

P. 25
Thinner: 6470 DFT per coat: 30 ì Theoretical coverage per coat: 13,7 m2/L Recoat time (20°C): min 12 Number of coats: 2 EUROSPRINT Long life antifouling CHARACTERISTICS Eurosprint is an antifouling with a high copper content. Suitable for any type of seawater, brackish and lake water

P. 24
22 ANTIFOULING PROTECTION OF THE HULL THE HULL CHOOSING THE RIGHT ANTIFOULING Antifouling is the most important product you will use when you are maintaining your boat and is essential in order to keep the hull in good condition. Antifoulings contain biocides, the active compounds

P. 5
3 Surface preparation page 12 Preparation and primer application on new or stripped boats page 14 Filler application page 16 Protection page 18 Protecting wood page 20 Antifouling protection of the hull page 22 Antifouling protection of special parts page 30 Painting an inflatable boat page

P. 26
that for one coat you will apply about one can every 6 m2. To obtain the recommended total thickness of 80-100 microns, you must apply two coats of the undiluted product using a brush. Using a roller tends to make the coat thinner. IMPORTANT Always apply the amount of antifouling advised. TABELLA